Freestanding Lace Machine Embroidery Design by Valery

To make this border place 3 FSL parts over the fabric. Pin in place. Using invisible thread, or the same thread as the FSL was done in, zigzag the parts to the fabric. Trim the excess fabric under the lace.

To embroider this design we used 40-weight polyester embroidery threads and 2 layers of water-soluble Stabilizer. Use the same thread for both the upper and bobbin thread to get two-sided embroidery.

147х130mm
St: 31900
Clrs: 1/1
In ZIP: DST, JEF, PES, VIP, VP3, HUS

Click on the picture to enlarge